...
The new NFS specific instructions are being included in 5770-BR1 7.2 and later releases and have the following characteristics:
The new information is printed in UPPER CASE English only.
The new steps are printed when the backup uses the DSI VTL iSCSI support implementation with control group QNFSIPLFUL.
The new steps are printed when the backup uses cloud control groups prefixed with QCLDBIPL or QCLDUIPL after they have been enabled for NFS support with one of the following commands:
In 5770-BR1 7.3 and 5770-BR1 7.4 run one of the following commands:
CALL QBRM/Q1AOLD PARM('SETUPFUN ' '*SET ' 'Q1ACLDNFS' '*JOB') - set up to for current job only
CALL QBRM/Q1AOLD PARM('SETUPFUN ' '*SET ' 'Q1ACLDNFS' '*SYS') - set up to affect all jobs
In 5770-BR2 7.4, 5770-BR2 7.5, and 5770-BR1 7.5 run the following command:
SETFCNBRM ACTION(*ADD) FUNCTION(CLDNFS) SCOPE(*SYS)
| Info |
|---|
NOTE: The SCOPE parameter also supports *JOB to only affect the current signed on job. |
Avoid Library Spanning
When reviewing your recovery report, it is critical to check if libraries QSYS2, QUSRSYS, or QGPL span optical volumes. Depending on where the span occurs, it may be an object that is needed by the operating system to process the volume switch which may make the library unrecoverable. If any of these libraries span, you should adjust your volume sizes and backup strategy to make every effort to avoid a volume span to ensure a successful recovery.
...